Spi arduino code12/6/2023 ![]() If the message is completely transmitted, the variable process is set to TRUE.A Serial Peripheral Interface (SPI) bus is a system for serial communication, which uses up to four conductors, commonly three. As long as the buffer is not completely filled with 50 characters, bit by bit is stored into the buffer from the SPI data register until the flag “\r” for the end of the character is found. First the SPI data is read form the internal data register and stored in binary form. Also interrupts are enables for the SPI communication.Īfter the setup function the SPI interrupt routine is defined. The SPI is set in slave mode and the two variables are set with their default values. The MISO pin is set as output to receive the data from the master. In the setup function, the baud rate is set to 9600 to view the SPI output in the serial monitor. The indx variable stores the index of the 8 bit and the process variable saves the current status of the transmission. The buff variables stores the incoming values via SPI. The slave script starts also with the inclusion of the SPI library.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |